Skip to content
DID YOU KNOW
Sign in with the Whop account you used at checkout to find your purchases.
SaleUse code GG for an extra 10% off
Guides
  • Cronus Zen
    • Zen Studio Live
    • Firmware
    • Switch
    • Mod Menu
GuidesLesson: Program it in Zen Studio Live

Lesson 2 of 8 · same for yew2K and yewFN

Program it in Zen Studio Live

Zen Studio Live writes the .gpc into one of the Cronus Zen’s 8 memory slots. This is the same for yew2K and yewFN. You only need the computer while you program. After that the script stays on the Cronus Zen.

1

Open Zen Studio Live in Chrome or Edge. Nothing to install: zenstudio.collectivemindsstore.com.

2

Plug a data USB-C cable into the Cronus Zen’s PROG port — the small port on the right side — and the other end into the computer. Charge-only cables power the Cronus Zen and do not program it.

3

Connect the device from the page. Open the .gpc you just downloaded, pick a memory slot, and hit Program. Wait until that slot shows the script name.

4

Unplug the PROG cable before you play. The right-side port is only for Zen Studio Live.

Which slot?
Any empty slot is fine. Remember the number — you select that slot on the Cronus Zen in the switch lesson. Programming a slot again replaces only that slot.
⁠Zen Studio reference⁠Zen Studio panels
PreviousDownloading the scriptNextUpdate firmware