In-game settings

These are the Fortnite controller settings published for yewFN. The script refines the stick, then Fortnite applies dead zone, curve, and sensitivity on top. Huge dead zones and an exponential curve fight that.

Look horizontal42–48%

Look vertical38–44%

ADS look horizontal14–18%

ADS look vertical12–16%

Edit mode sensitivity1.4–1.6×

Look dead zone5–10% (as low as the sticks allow)

Response curveLinear

Aim assist strengthMaximum

Build bindsBuilder Pro

SprintToggle

Edit bindA paddle, or L3 if you have no paddles

Over 12% dead zone

If the sticks drift until the dead zone is past about 12%, the published note is to replace the sticks. A fatter dead zone eats the script’s small aim corrections.

Match your Fortnite settings

Set the left and right stick dead-zone values on Script Download to match the corresponding values in Fortnite. Choose the same input curve you use in-game. These settings are saved into your script, so update them and download a new file if you change them in Fortnite. The sliders support 5–25 and start at 10; the input curve starts at Linear. Confirm edit on release is a personal choice — try both for a full session.

Change one thing

The published testing note is one variable per session: creative for ten minutes, then three matches, then decide. Mid-range tracking is the check.

PreviousInstall a script update NextSwitch to the script

Lesson 5 of 8